• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > MOM and Schematic not matching

MOM and Schematic not matching

录入:edatop.com    点击:
Hello everyone,

I am using ADS 2012.08 and I am designing a Power Amplifier for 5.9 GHz. Regarding this situation I chose NPT2018 transistor and I'm using the ADS model provided by the manufacturer.


After doing the Impedance matching networks in schematic (using optimizations and goals) I am now trying to do the momentum simulation and the results have been catastrophic. I think I have considered the proper way of doing it, specially considering rough transitions.

Attached you can find the output schematic and layout versions. What is happening is that I lost all the gain (-20 dB right now) and efficiency, of course. In the Schematic version the Mgap was used just for layout purposes.

I would like to know what possibly I am doing wrong, since I've configured the substrate as well and I think I set the ports correctly (Ports1,2 and 3 are TML and the other ones are SMD because of the capacitor.

Thanks a lot everyone.


附图/附件

layout.pdf

schematic.pdf

At what part of the OMN do you bias the device?
Have you checked the isolation of the biasTee?
Have you tried to attach the schematic (not MoM) version of OMN you showed to the transistor and optimze the full circuit?
Try to take small parts of the schematic and EM them one by one with attaching them to the schematic after EM'ing.
Try to put a DC-Block or a large cap between SNP ground pin and ground, sometime DC leaks throug the ground pin of SNP.

Hope that helps.
Regards

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:PDN Impedance
下一篇:Why TDR impedance varies for my Transmission line and corresponding s-parameter file

ADS培训课程推荐详情>>

  网站地图