- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
铺铜时出现这样的报告是怎么回事
录入:edatop.com 点击:
大家好!我用的是pads2007,有时候我在做完LAYOUT后铺铜时出现这样的报告,如下;
THERMAL RELIEF ERRORS REPORT -- WD04569aF3-0.pcb -- Tue Apr 10 16:09:27 2012
Drilled pads with Nondrilled pads with
less than 50% thermal extensionsless than 50% thermal extensions
Report of Thermal Spokes Generator.
On Bottom:
C12.2 (36.9, 6.025) # = 1
C9.2(11.5024, 6.5) # = 1
Total Drilled pads:0 Total Nondrilled pads:2
请问大家这是哪里有错误呢。请各位指教!
THERMAL RELIEF ERRORS REPORT -- WD04569aF3-0.pcb -- Tue Apr 10 16:09:27 2012
Drilled pads with Nondrilled pads with
less than 50% thermal extensionsless than 50% thermal extensions
Report of Thermal Spokes Generator.
On Bottom:
C12.2 (36.9, 6.025) # = 1
C9.2(11.5024, 6.5) # = 1
Total Drilled pads:0 Total Nondrilled pads:2
请问大家这是哪里有错误呢。请各位指教!
你的问题我以前也遇到过,pads layout里tools->options->thermals的菜单下,有关于设置贴片焊盘和插件焊盘接地使得的铜箔线的宽度和数量,注意min.spoke项,铺铜的时候你的C12.2和C9.2的接地铜的铜箔线数量应该是少于你设置min.spoke的值,才会出现这个问题的吧!
射频工程师养成培训教程套装,助您快速成为一名优秀射频工程师...
天线设计工程师培训课程套装,资深专家授课,让天线设计不再难...
上一篇:Offsets are too small -- plot will be center?
下一篇:铺铜时出现错误,不知道什么原因,求指点
射频和天线工程师培训课程详情>>