• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > 电子设计 > PCB设计 > PADS设计问答 > 求救.ORCAD原理图导到PADS2007找不到封装

求救.ORCAD原理图导到PADS2007找不到封装

录入:edatop.com    点击:
Reading file --E:11DESIGN1.asc
Can't find part Type item
R121 SR0603
Can't find part Type item
R122 SR0603
Can't find part Type item
U1 LED24
*Part name not found R121
R121.1
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal LED
*Part name not found U1
U1.3
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal MCU_VDD
*Part name not found R122
R122.1
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal GND
*Part name not found U1
U1.4 R121.2
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal N00160
*Part name not found U1
U1.1
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal VDD5V
*Part name not found U1
U1.2 R122.2
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal N00204
Warning: deleting signal LED
Warning: deleting signal MCU_VDD
Warning: deleting signal GND
Warning: deleting signal N00160
Warning: deleting signal VDD5V
Warning: deleting signal N00204
**INPUT WARNINGS FOUND**
但是我的pads库里是有这些元件呀,可是就是说找不到,不知道怎么回事,请高手解答一下谢谢

我也是,不知道怎么回事知道的说下啊

初学,同问!

pads layout中你没有创建对应的PART TYPE:LED24 和SR0603

确认下PADS 库里面的 SR0603LED24是在Part Types .还是 Decals. 要为PART TYPE 才可以.

楼上正解,如果是通过import*.asc文件将sch网表导入layout中,library中必须要有对应的Part Type和Decal才行!
如果是在dxdesiger中直接将网表由Cross Probe导入,则不需要

射频工程师养成培训教程套装,助您快速成为一名优秀射频工程师...

天线设计工程师培训课程套装,资深专家授课,让天线设计不再难...

上一篇:PADS2009安装
下一篇:急 电子元器件封装尺寸规范?》

射频和天线工程师培训课程详情>>

  网站地图