• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > 电子设计 > PCB设计 > PCB设计 > 高通平台手机PCB设计常用英文

高通平台手机PCB设计常用英文

录入:edatop.com    点击:

BCCP:Bump chip carrier package

CAD:Computer aided design

CP:Charge pump

DCN:Document control number

GPS:Global positioning system

LNA:Low noise amplifier

mil:0.001 inch (0.0254 mm)

MSM⑩:Mobile Station Modem⑩

PA:Power amplifier

PCB:Printed circuit board

PLL:Phase-locked loop

PM:Power management

QCT:QUALCOMM CDMA Technologies Division

QFN:Quad flat no-lead package

RFL:Radio frequency LNA

RFR:Radio frequency receiver

RFT:Radio frequency transmitter

SBI:Serial bus interface

VCO:Voltage-controlled oscillator

VCTCXO:Voltage-controlled temperature-compensated crystal oscillator. Referred to as TCXO in this document.

Zero-IF:A radio architecture that converts received signals directly from RF to baseband, thereby eliminating the intermediate frequency necessary in super-heterodyne receivers. The transmit signals likewise eliminate the Tx IF, upconverting directly from baseband to RF.

ZIF:Zero-IF



射频工程师养成培训教程套装,助您快速成为一名优秀射频工程师...

天线设计工程师培训课程套装,资深专家授课,让天线设计不再难...

上一篇:PCB设计SDRAM线序调整原则
下一篇:高速PCB设计中信号完整性分析(二)

射频和天线工程师培训课程详情>>

  网站地图