I want to Make 1kW 13.56Mhz dummy load by paralleling cement resistor

I found HF Dummy load are too expensive to afford ,
I wonder if there's possible to paralleling 20's of50W cement resistor for achieve 1kW Dummy Load?
because I test One 50 Ohm single cement has 50nH inductance with LCR meter .
So theorem speaking , after parralleling 20 same 200 Ohm cement resistor , I can get 2.5nH and 10 ohm
Resister load , so I can almost get pure resistive Load.
Is it possible ?orRF dummy Load is the only solution?

Parallel resisitors can work very well as a dummy load so long as you work within their limitations. I have made a 100W load from 2W resistors. It got rarther large and the strays limited the frequency at which the match was good, but it was adequate for my needs and a lot cheaper than a ready made one. You can tune out the inductance to get a good match at a spot frequency if you ned to. Don't forget to screen it well, both from the RF leakage point of view and for safety reasons.
Peter

because I test One 50 Ohm single cement has 50nH inductance with LCR meter .
So theorem speaking , after parralleling 20 same 200 Ohm cement resistor , I can get 2.5nH and 10 ohm You're apparently assuming constant ESL independent of resistance values. That's highly unlikely because resistors differ both by wire gauge and number of turns. Another point to consider is skin effect of resistance wire. For an exact calibrated dummy load, you'll hardly avoid to measure the actual impedance at 13.56 MHz with a network analyzer or RF impedance bridge.
If your application is 13.56 MHz with small bandwidth, compensation of ESL shouldn't be a problem. But in general, low inductance resistor technologies with thin resistor elements (less skin effect) would be preferrred.

Is it possible to adding Capacitor in series with Load resistor to cancel the inductivity from resistor Load ?

Yes, though it may be easier to use a shunt capacitor. As FvM says you will need to make a measurement and see what you actually get at 13MHz, it may not be what you expect from a measurement on a single device.
I I were making a load for use at 13MHz I would use TO220 resistors, unless of coarse I had the vitreaous enamel resistors already.
Peter

申明：网友回复良莠不齐，仅供参考。如需专业学习，请查看13.56MHz NFC/RFID天线设计培训课程。