• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS使用问答 > 用ADS2012.08做功分器的仿真优化时出现以下错误,请问怎么....

用ADS2012.08做功分器的仿真优化时出现以下错误,请问怎么....

录入:edatop.com    点击:
Simulation Messages
Error detected by hpeesofsim during Nominal Optimization `Optim1'.
    Swept vectors/matrices not supported in an OptimGoal/YieldSpec. Must use a (swept) scalar
Error detected by hpeesofsim during Nominal Optimization `Optim1'.
    'Optim1[1]': circuit simulation fails.
Error detected by hpeesofsim during Nominal Optimization `Optim1'.
    Optim1[1] can't do cost evaluation.
Error detected by hpeesofsim during Nominal Optimization `Optim1'.
Status / Summary

hpeesofsim (*) 390.shp Nov 21 2012 (built: 11/21/12 12:56:57)
Copyright Agilent Technologies, 1989-2012.
OPTIM Optim1[1] <equal_divider_lib:equal_divider_Optimization:schematic>  optIter=(0->100)
SP Optim1[1].SP1[0] <equal_divider_lib:equal_divider_Optimization:schematic>  optIter=0  freq=(900 MHz->1.1 GHz)

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:ADS仿真混频器和滤波器的S参数问题
下一篇:如何将ADS中的版图导入到protel中

ADS培训课程推荐详情>>

  网站地图