controlled impedance line designer - simulator terminated unexpectedly

I'm following the Quick Start Tutorial for Controlled Impedance Line Designer found in ADS help. I've followed all of the directions but when I hit simulate in the controlled impedance line designer gui I get the following error:

Simulator terminated unexpectedly: exit code= 120 exit status= 0

Anybody know what this could be? I'm using ADS 2014.01.

snowbot on Jul 29, 2015 9:09 AM

Hi,
I think I have seen this in the past.
as far I remember this was the message when no license is available.
In this point in time there was a separate lic required to run the impedance line designer .. not sure if this is still the same.

I guess you should contact your local FAE and ask if this is still the case, and check with your admin what features your license include.

I can not promise if this is the reason, but give it a try to search in this direction ..

Hermann

Thanks for the reply. I haven't been able to confirm this but I suspect you're right. I'm able to use line calc and that has been sufficient for my needs so far.

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。