- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
Convergence error in simulation with an EM model
录入:edatop.com 点击:
Convergence errors occur in a simulation with an EM model in harmonic balance simulation.
But there is no convergence error in a simulation with electrical models(microstrip line models and so on) of ADS.
The error only occurs with its EM model extracted from its layout.
I read the document of convergence error in harmonic balance simulation in the manual of ADS.
I tried applying the techniques suggested in the document, such as changing the OSR, using TAHB, auto(preferred) convergence mode, advanced (robust) convergence mode, changing iterations to robust and custom with 1000, direct solver, Krylov solver, Matrix re-use robust, custom, Krylove Restart length (robust, low memory, custom), and so on...
I also tried changing some of advanced continuation parameters and advanced krylov parameters.
But still no success in convergence.
What could I try to reach the convergence?
Thank you very much.
But there is no convergence error in a simulation with electrical models(microstrip line models and so on) of ADS.
The error only occurs with its EM model extracted from its layout.
I read the document of convergence error in harmonic balance simulation in the manual of ADS.
I tried applying the techniques suggested in the document, such as changing the OSR, using TAHB, auto(preferred) convergence mode, advanced (robust) convergence mode, changing iterations to robust and custom with 1000, direct solver, Krylov solver, Matrix re-use robust, custom, Krylove Restart length (robust, low memory, custom), and so on...
I also tried changing some of advanced continuation parameters and advanced krylov parameters.
But still no success in convergence.
What could I try to reach the convergence?
Thank you very much.
Try to check the biasing of the non-linear device, quite often not a proper biasing leads to convergence issues.
Also you can check the small signal stability when running s-parameter simulation, since s-parameters should still run, and if it is not stable there - that would be the cause for convergence issue.
Hope that helps.
Regards
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:eesofpvm
下一篇:AEL Batch Simulation
ADS培训课程推荐详情>>
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集