• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Nested Parameter Sweep

Nested Parameter Sweep

录入:edatop.com    点击:
I need to do a nested parameter sweep of 7 independent variable/parameters on a Transient analysis.

In the help files, it was shown how to do a 2 parameter sweep on a DC analysis and successfully did that whilst being in Transient Analysis (sweep_config1.png).

Yet in those documentation, it wasn't explicitly shown how to go higher than 2. So I've been trying this setup (sweep_config1.png). It's still only 2 parameters, but meant to extend more, through Sweep Plan and Parameter Sweep pointing alternatively to each other.

In the Display, what I seem to be getting are 2 separate sweeps, but not nested.

It's also possible that I'm not using Sweep Plan properly, so I couldn't set the "Parameter to sweep", so I made it point to another Parameter Sweep.

ren_zokuken01 on Mar 21, 2016 12:51 PM


附图/附件


sweep_config1.png


sweep_config2.png

Have one parameter sweep call the second parameter sweep rather than both calling the Transient controller. You might find it simpler to run a Batch simulation.

Running a batch seems to output everything in CSV and I don't want to have to learn how to feed that CSV to the Display (I don't even know if you can). So I'm sticking with this approach.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:How to extract BSIM3 capacitances with a DC sweep?
下一篇:eesofpvm

ADS培训课程推荐详情>>

  网站地图