- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
EMmodel error: Evaluate model for default parameters.
EMmodel error: Evaluate model for default parameters.
What's wrong with it?
Analysis "Solve" (M181223002726) of design HWRes_lib:R_Concept:layout_defPara_v1 failed:
--- ERROR ---------------------------------------------------------------------
A calibrated pin must not be positioned on an
edge on which other pins are positioned.
(Using a single calibrated pin simultaneously in
several ports is also invalid in this respect.)
The pins involved are "tlineP111_P2" and
"TFR_TaN10_P2".
-------------------------------------------------------------------------------
Consult the Job Manager log for full details.
Log say:
--- WARNING -------------------------------------------------------------------
... Several similar warnings...
The port setup needed to be corrected:
TML calibration for port "tlineP99_P1" has been
changed to TML (zero length) calibration because
the transmission line of pin "tlineP99_P1" would
otherwise intersect with the layout.
-------------------------------------------------------------------------------
Generating mesh at 68 GHz...
--- ERROR ---------------------------------------------------------------------
A calibrated pin must not be positioned on an
edge on which other pins are positioned.
(Using a single calibrated pin simultaneously in
several ports is also invalid in this respect.)
The pins involved are "tlineP111_P2" and
"TFR_TaN10_P2".
-------------------------------------------------------------------------------
Hello,
the error is what the message says: "A calibrated pin must not be positioned on an edge on which other pins are positioned."
It seems that you have two pins (ports) on the same polygon edge. Note that a pin on the edge will result in a port that spans across the entire width of that edge, and doesn't stop at vertices in between. Example: If you have a T-junction and a stub, that might result in one wide edge from of T-junction plus stub, if the are in line with each other.
Regards,
Volker
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:How to simulate Multi-port excitation in ADS?
下一篇:Viewing Momentum simulations during cosimulation from a schematic
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集