• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > doing simulation in ADS for pulsed RF loadpull

doing simulation in ADS for pulsed RF loadpull

录入:edatop.com    点击:

hi

i wanted to do the simulation for GaN device under pulsed rf and pulsed dc condition. would you please help me how sahould i do that? is it possible to guid me how should i do loadpull at this conidtion?! my main problem is how to impelemt and program the pulse condition in the ADS.

Dear Yashar,

If your device's simulation model implements some kind of time dependency (like self-heating), you will need the Circuit Envelope simulator and use a time-domain (voltage) source for your bias circuitry and a pulsed-RF source for your RF signal. On both sources you specify the pulse start and duration. All your simulation results now have both a time and frequency (i.e. harmonic index) dependency. For your load-pull results analysis formulas you need to select a time-point somewhere in the pulse, to remove the time dependency.

If your device's simulation model does not have any time-dependency, you don't need to do a pulsed simulation and get by with CW and Harmonic Balance simulator.

Sincerely,

Herman Westra
Technical Consultant
Keysight EDA

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Need help with DAC
下一篇:How to change units in Momentum layout while taking care of scaling?

ADS培训课程推荐详情>>

  网站地图