• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > copying ports from em setup

copying ports from em setup

录入:edatop.com    点击:
I'm wondering if there's a way to copy the ports from one em setup to another em setup while retaining the signal and reference relationship between ports? Also is there a way to change the calibration for all ports at once?

If I'm simulating a similar-to design I can copy and paste all the ports from one layout to another layout but the em setup recognizes that the ports have changed and therefore reloads port information from the layout. So the signal-reference relationship between pins is not kept. i.e. I have to drag all of my reference pins back to the minus terminals of my signal pins again). This takes a lot of time!

Ideally I should just make a copy of the cell and make any layout changes in ads, but I'm doing layout in cadence and therefore want to make all of my changes in cadence and just use ads for simulation. If I exported a gds from ads, and imported it in cadence I would lose my original hierarchy I had in cadence which is undesirable. Any suggestions?

If it's not a possibility to do this, this would be a great feature that would save me a ton of time.

snowbot on Oct 7, 2015 9:20 AM

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Cannot attach Linearization DesignGuide
下一篇:mesh option for memtum

ADS培训课程推荐详情>>

  网站地图