ADS Command Line Simulation Export Format

Hi,

I have managed to run a simulation of a netlist from the command line using the command:

hpeesofsim -r output.log netlist.log

I would like to read the output file to another program but I can't figure out how to properly access the data.
For example, a simple resistor divider gives the following output file:

File Format: MDS
Revision: 2.01
Title: netlist.log
Date: Wed Mar 11 13:31:40 2015
Plotname: TRAN Tran1[1] time=(0 s->10 ns)
Flags: real
No. Sweep Variables: 0
Sweep Variables:
No. Variables: 5
Variables:0timetime type=real indep=yes
1V2voltage type=real indep=no
2V1voltage type=real indep=no
3SRC1.icurrent type=real indep=no
4tranordernone type=real indep=no mixop=none
Binary:8:GFEDCBA@
$@ @ðh㈵øÔ¾ ð?
—dyáý¥= $@ @ðh㈵øÔ¾ ð?
—dyáýµ= $@ @ðh㈵øÔ¾ @
¼½×Ùß|Ë= $@ @ðh㈵øÔ¾ @
8JåÏ=ã= $@ @ðh㈵øÔ¾ @
âˆãØË,ü= $@ @ðh㈵øÔ¾ @
à³çâõ > $@ @ðh㈵øÔ¾ @
:E‡åÔ #> $@ @ðh㈵øÔ¾ @
„°šÙÚ¨+> $@ @ðh㈵øÔ¾ @
ç
×fð 2> $@ @ðh㈵øÔ¾ @
ŒÃà`sk6> $@ @ðh㈵øÔ¾ @
1yêZö¶:> $@ @ðh㈵øÔ¾ @
Ö.ôTy ?> $@ @ðh㈵øÔ¾ @
ò~'þ¦A> $@ @ðh㈵øÔ¾ @
̓¤¿ÌC> $@ @ðh㈵øÔ¾ @
:Œ0â?yE> $@ @ðh㈵øÔ¾ @#

Does anyone know how I can read this or save it differently?

Thanks.

Hi,
you can use Write_var in the schematic to write an ascii file with the data you want to have.
This will be executed automatically after the simulation is finished.
I used this with a separate netlist that was included in order to change the equations with a good text editor.
I think there should be an example in the DDR3/DDR4 compliance workspaces (not sure if this solution is still used there or if there is already something new).

and some time ago there was another request in the forum for writing out data directly from the simulation.
This was done by another command (please check the forum).
There have been some examples with ADS that showed how this command is used.

not sure if this is what you are looking for ...

Hermann

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。