• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Momentum port setup at transistor input above 100 GHz

Momentum port setup at transistor input above 100 GHz

录入:edatop.com    点击:
Hello all,

I am currently designing an MMIC LNA above 100 GHz. For simulating transmission lines, differential port setup with Metal1 referenced ports without any calibration works just fine. However I am confused about how to setup ports at transistor terminals. Reference pins at PEC give unphysical results so I place them at the closest ground plane (Metal1). This gives 'meaningful' results but I'm not sure if this is the correct port setup since I'm grounding the reference pins at schematic level but my real grounding point is further away.

Attached files show the layout and schematic. It feels like with this setup I'm omitting the resistive path to my real ground but other setups I've tried did not work. What is the best way to define ports (and ground) in this situation?

Other question is about the ground pin in momentum. I did not see any difference in results when I place this component in the layout so I'm wondering what exactly does this ground pin do?


附图/附件


portsetup_schematic.JPG


portsetup1.JPG

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Failed to write LTD file to Disk
下一篇:Problem with EM Mesh frequency and Mesh Density

ADS培训课程推荐详情>>

  网站地图