Spiral inductor (unconnected ports) -ADS Agilent software

Hi,

Could anyone help me with Agilent ADS software ?

I wish to draw a flat spiral coil (17 turn, s=w=0.5mm)

I'm not knowing how to connect ports (P1-P2===>) to terminals of an spiral inductor layout.

I try to connect ports (P1-P2) in the flat coil and the connection between them is unsuccessful .

After to simulate the flat spiral coil appears message following:

"ERROR !"

"unconnected ports" .


Can I send the layout file for analysis.

José Soares

If you have placed the pins on the layout, and there is no connection for EM, then your layer is not mapped properly in the EM substrate definition. In this case, you will also see an error indicated in the port section of the emSetup dialog. Solution: include the layer in your EM substrate defintion.

Hi volker@muehlhaus

I am going try your sugestion and will reply to you soon later.

Thanks

José

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。