• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Query about ADS Simulation

Query about ADS Simulation

录入:edatop.com    点击:
Hello everyone,

I want to simulate a circuit which consists of some resistors[50ohm,1600ohm,10ohm],capacitors[10pF] and diodes. I need to check the S-parameters[S11, S21] from 1 GHz to 50 GHz of this circuit by using ADS Design tool. Is it right to just place an ordinary resistors,capacitors and diodes available in ADS Lumped components list to make a schematic?

First,I have to calculate the S-parameters at schematic level. Than I shall make the layout design of this schematic by using ADS Momentum. I used 50 ohm port termination at input/output port of my design.Than I computed S-parameters. Am I doing right so far?

Thanks in advance

What do you want to do ?
If your purpose is just ideal simulation, answer is right.

If you would like to simulate actual discrete components, use libraries which vendor provide.

Many vendor provide libraries for ADS.
For example, http://www.murata.com/en-global/tool...xxx_cmn_hd_xxx

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Rad. of Patch integrated with Diode switch and other lumped components in ADS & EMPro
下一篇:SOCLIN ADS calculator and book example mismatch

ADS培训课程推荐详情>>

  网站地图