• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > S-Parameter calculation by ADS

S-Parameter calculation by ADS

录入:edatop.com    点击:
Hi all,

Could someone explain how I can calculate S-parameters of RF circuits by ADS?

Regards

Hi mrasooli

when Ads or any other Rf software dose a simulation, it's automatically doing S parameters calculation and you can see results(S parameters) from post processing

I hope it'll be helpful

First, draw your circuit in Schematic window using lumped-component or TLines .... whatever you want. Then select Simulation-S_param from the drop-down list from left. Here you can select the "Term" component which will be your ports (connect the "term" components at the ports where you want to calculate the S-parameters, don't forget to connect the ground at - of the "term"). Select "S P" where you define your frequency range (start, stop, step etc.). Finally, run the simulation. After simulation, you can select your desired S-parameters in data display window.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:LANCZOS ALG failure with internal ports in ADS EMDS?
下一篇:Inductance simulation with agilent ADS

ADS培训课程推荐详情>>

  网站地图