• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Urgent how to get half wave rectifier output voltage using ADS

Urgent how to get half wave rectifier output voltage using ADS

录入:edatop.com    点击:
When I open the example of rectifier from ADS2009, I can not get the output voltage as half wave of sine. How could I get this?

---------- Post added at 10:06 ---------- Previous post was at 09:32 ----------

I supply sufficient AC voltage but output voltage is again full wave. What should I do?

add resistor 5k to grd
as load

I have done it many times . Output voltage is always the same like input.

Here I share the picture of simple circuit and input-output voltage . what should I do to get half wave sine?

Remove 50 Ohm resistor before the diode and see what happens.

I removed then output is equal to input

20 GHZ !
the cap of the diode is making a problem, your diode id not conducting (increase to 5v ac pp )and at that freq u have all kinds of matching problems .
first reduce the load to 50 ohms, next try putting the diode in parallel after the 50 ohm and u will have half wave shorted at that's what made usually in hi freq. your scope should be in dc mode...
is that a model or real circuit ? reduce freq to 1Mhz and post the result.
sdd_diode why cant i find it in internet send data or link.

Hi,
Try to work at Transient not at AC.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:needs more metal layer in ADS Momentum
下一篇:Problems in: Co-simulation ADS2011 and EMpro2013

ADS培训课程推荐详情>>

  网站地图