- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
ADS Rectifier Simulation
The correct engine you have to use is transient. It performs a non-linear time-domain simulation.
Tha AC analysis is instead a linear analysis in the frequency domain: the generator sweeps the frequency range you choose. A frequency is generated and the ouptut is calculated at that frequency, then the generator is moved to the next frequency and the measurement is repeated and so on, until the whole range is swept.
However the diode will cut the voltage lower than its knee-voltage (roughly 0.7V or 0.4 in case of schottky barrier). From your schematic you add a DC voltage of 1V to a sinewave of 1V amplitude, then the signal reaching the diode will range from 0 to 2V. Only a small part of the sinewave, and not a half wave will be cut-off. You should increase the singnal amplitude or reduce the DC voltage. If you have in mind a biased RF power detector you have to bias the diode by means of a small current, not by means of a voltage.
Of course the diode must be fast enough with respect to your working frequency.
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:ads momentum help
下一篇:EMDS vs Momentum in ADS 2009? - for antenna properties
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集