- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
Changing of center frequency after layout simulation in ADS
I am designing a bandpass filter at 5.81 GHz center frequency using ADS. However on simulating the layout, the center frequency shifts to 5.5 GHz.
Hi Twisha,
You haven't provided much information, but I'm guessing your original design was in the ADS schematic editor. The layout view and simulator is a full-wave simulator, which takes into account things like parasitics and various transmission-line effects that your schematic might not have. The layout result, if you meshed properly, is more accurate.
Good Luck
If you used discretes (Caps, Inductors), this might be due to the size of the
Components. There's always potential for a little difference from simulation
Small Signal/ S-Param and layout 2.5D Simulation. The 2.5D sim is better
at higher frequencies (typically). You will have to do experiments to see
which methods are more accurate for yourself. i.e. put both circuits on
PCB and see which is better (if Possible)
Hi Twisha,
This is not a issue, as @PlanarMetamaterials said the results of full wave simulator will not always be equal to Schematic simulator, you can use EMmodel instead of Schematic components to optimize to get exact values of EM results. Also your EM results(Layout) are accurate and close to real world designs.
-------
Amit
ADVERTISING LINK REMOVED
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:Can finite ground CPW design use ADS linecalc in ADS?
下一篇:FEM vs. Momentum simulation in ADS 2009U1
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集