- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
ads spiral inductor
录入:edatop.com 点击:
I am designing a mixer to operate at 2.4 GHz.. and have an inductor that has to be grounded in the matching network...since I am using microstrip i know i'll have to drill a hole to connect it to ground but...is spiral inductor the best route to go or an air core inductor which i'll have to wind myself...also when designing a spiral inductor in momentum,,, I define the substrate as: free space ->air(10 mil)->dielectric(εr=2.2) ->///GND///...now this is supposed to represent the metal for spiral turns(in the cond layer below free space), the under pass(above the delectric i.e. cond2 layer), and the air layer between them is meant for the via( in the resi layer) to connect these two....am I doing this right? and what about the dimensions of the via and underpass metal to connect the centre of the spiral to the next component or line and what kind of a metal via shuld I use...circular or what....and also when i have to ground the inductor which follows a capacitor..I think i should connect the centre of the spiral to the capacitor and drill a hole and connect the outer most line of the inductor to the ground in microstrip...will that be alright? any help will be appreciated...thnx
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:Antenna Design using ADS
下一篇:Agilent ADS problem: mu() factor for stability
ADS培训课程推荐详情>>
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集