• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Replace Lumped Circuit Design by microstrip in ADS

Replace Lumped Circuit Design by microstrip in ADS

录入:edatop.com    点击:
I don't know to replace Lumped Circuit by Microtrip in ADS. It is dificult because I don't know fomula to caculate.
Example capacitor (C= 1.728 Pf) is replaced by MBSTUB W=40 mil anh angle 60
L=3.129 nf is replaced by Mlin W=115 mil and l =300 mil
You show me to design it. (book or software or caculated)
thanks!

you can take a look at any microwave book, specifically at filters section. I recommend Microwave Engineering by Pozar. In the filters section it should explain how capacitors and inductors are realized by microstrip lines.

Notice that small segments of open-ended or short-ended microstrip line segments (stubs) act as inductors or capacitors...

Thanks Zottiri Kusuta
I design with frequency in range (88-108 MHz).So, microstrip such as L,C is big ?.

It is natural that at lower frequency LC realization is impractical and use discrete one

You can take a simple RLC circuit and compare it with a microstrip circuit using tune tool available in a an circuit simulator....

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:ADS Schematic Substrate Definiton
下一篇:Can exported HFSS equivalent circuit file to be used in ADS?

ADS培训课程推荐详情>>

  网站地图