• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Even/Odd Mode Impedance Simulation of Patterned/Finite Ground Plane in ADS Momentum ?

Even/Odd Mode Impedance Simulation of Patterned/Finite Ground Plane in ADS Momentum ?

录入:edatop.com    点击:
Hello,

I'm currently designing a Patterned (w/ Slots) Marchand Balun to increase the Even/Odd Impedance Ratio for good balance.

LineCalc is able to simulate Zoe and Zoo given the width and spacing of a coupled lines but it assumes an infinite ground plane.

However, for the patterned ground plane, the LineCalc would not be applicable. Any idea on how to simulate this using ADS?

"There is 2 way to do this:

1) Define the Defected Ground Structure (DGS) on the SLOT layer.
2) Define it on the STRIP layer and assign ground reference ports on it.

Hamid"

Or you can use a 3D simulator like HFSS and CST.

Microwave123

Hi,

I appreciate your inputs.
ADS2009 actually have an integrated full 3D simulator which is the EMDS. Are you familiar with this?

---------- Post added at 08:59 ---------- Previous post was at 07:46 ----------

Simulation in ADS Momentum only yields S-parameters. I don't think it is able to output the even/odd impedance data for the coupled lines in a Marchand Balun.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Error when doing S-parameter fitting using ADS optimization
下一篇:Help me with dipole antenna design in ADS

ADS培训课程推荐详情>>

  网站地图