• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Error when doing S-parameter fitting using ADS optimization

Error when doing S-parameter fitting using ADS optimization

录入:edatop.com    点击:
Hi Guys,

Now I am doing S-parameter fitting using ADS optimization(fit the response of the equivalent circuit model to the measurement result). While I had a problem here: when the error function goes very close to zero, the optimized curves are much more different.

I am confused here. Do you guys know what's going on? Thanks for help!

Hi. I am so confused in how to do this fitting. I got the s parameters from HFSS and had built the equivalent circuits for my model. Could you please give me a detailed structure of how to get the value of equivalent L and C. If you got a manual for this, that would be better. I looked up on the internet, but the information is so limited. I appreciate your help.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:how to use a 3-port transformer in ADS
下一篇:Even/Odd Mode Impedance Simulation of Patterned/Finite Ground Plane in ADS Momentum ?

ADS培训课程推荐详情>>

  网站地图