- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
rectangle - variable - ADS2008 Layout
I′d like to simulate a rectangle (cut out in ground plane). The dimension of this cut out should be set with variables.
example: corner1(x1,y1) corner2(x2,y2).
x1,x2,y1,y2 are variables.
I know, how to define variables but I don′t know where I can use them for the rectangle.
microstrip lines can be set with w and l (variables)..and the same I need for a rectangle.
Do you understand =)
nice greetings
In ADS layout, you use variables by moving vertices. So, if you would like to increase the width of your rectangle, you grab the two corresponding vertices, and move those by the desired amount. If you current width is X, you can specify the variable to have a nominal value of X with a perturbed value of X + the amount that you move it.
First, draw your nominal rectangle. Then go to Momentum\Component\Parameters
Enter a name for your variable, the nominal value, and the perturbed value. Then click "Add".
A new layout will open up, and you grab the corresponding vertices, and move them by the perturbed value. Then click "OK", and you should be set.
Good Luck!
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:Adding vendor transistor model in ADS--Error: unable to access library
下一篇:Re: probleme dataset ads...
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集