• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > how to reduce the sidelobe level of patch array antenna using ADS

how to reduce the sidelobe level of patch array antenna using ADS

录入:edatop.com    点击:
hi..
how to reduce the sidelobe level of patch array antenna using ADS.

Hi,

What sort of array is it ? When you look at the Balanis's book, you will see that if the distance between the patch is more than one half wavelength, the pattern of the array has more sidelobe but the main lobe is more directive. So if you want to minimize the sidelobe, you have to optimize the distance between them. In layout ADS, you can't put any parameters or do any optimization, you can only simulate step by step your array.

Hi

Thanks for your reply..This is 4X4 patch array antenna . The gain is 18.33db and first sidelobe is 4.335.element spacing is .9lamda.. How to get 25db sidelobe suppresion?

Hi,
It seem to me that your gain is a little bit high for the main lobe. Perhaps an simulation error ?
THe gain for your first sidelobe is high too. Normaly, a patch antenna alone has a gain of about 6 dB. The array of 4 patch add a gain of 6 dB so your main lobe must have a gain of 12 dB.
What sort of patch (rectangular, circular ...) do you use and what is your dielectric properties ?
Moreover your spacing is too high, with a distance of 9 lambda you must have more than one sidelobe but a gain of the mainlobe important.
Try to decrease your distance between elements ....

HI

This is 4X4 array there are 16 patches and this is rectangular patch.Dielectric properties are

1.RTDurroid 5880 with Er=2.2 , h=0.254mm

Apologize, ok for the 18 dB gain. Try to reduce the distance between elements.

Hello,

The high side lobes level can be reduced by used chebyshev method (in order 1, 2, 3, ...) or Legendre method (in order 1, 2, 3, ...).
they are reduced side lobe level of the array antenna.

Goodluck

Hi

thanks for your reply.. can u explain how to apply chebyshev method to patch array antenna?

you have essentially an array of two elements, the firs side lobe you see is the grating lobe, sorry you cannot do anything to reduce it, just try to keep the element closest to taper such grating lobe with the element factor.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Which port should we use in ADS for coax feeding?
下一篇:How can I use a .s37p file in ADS

ADS培训课程推荐详情>>

  网站地图