• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Isolate Terminals in ADS?

Isolate Terminals in ADS?

录入:edatop.com    点击:
Hey guys,

In an ADS schematic let's say I have two 2-port networks. A S parameter simulation would give a scattering matrix for a four port but ports 1&2 do not interact with ports 3&4.

Is there a way to tell ADS that I only want S11,S22, S21, S12 and S33,S44,S34,S43?

If Sija are completely uncorrelated with Sijb, why don't you seperate these two s-parameter dataset into 2 independent block? In this case There won't be interstage s-parameters..
Since you use 4-ports in ADS, the simulator will naturally compute all s-parameters even they are not correlated.

I think you want to compare two different 2-port results?

You can simulate with two independent schematics, so that you have two 2-port datasets. Then in the ADS data display you can plot results from different simulations (different datasets) in the same graph, if you wish. Just use the dropdown list in the upper left corner to select the dataset that you want to add to the plot, then select the parameter that you want. You can also use data display equations to calculate something from different datasets.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Help Required in designing a 3 port filter uisng ADS2009
下一篇:Analysis and Design of X-Band LNA in ADS

ADS培训课程推荐详情>>

  网站地图