• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Plot the phase noise of LC-VCO in ADS

Plot the phase noise of LC-VCO in ADS

录入:edatop.com    点击:
Hi;
I designed a LC-VCO in ADS and i should plot its phase noise. I persued a clear Tutorial so i used HB simulation. I will send the ADS file of output voltage and the parameter which i used in HB simulation to undestand more the matter. After doing all of these steps, i can't plot the phase noise spectrum. What can i do and how can i solve this matter. I ask if the matter in the offset frequency or in another parameter in HB simulation.

Describe your situations in detail.

I have designed an LC-VCO at frequency 12.8 GHZ and i would like to plot the phase noise. I used a tutorial to do this. However, when i run simulation i can’t plot the phase noise spectrum, as it is clear that the curve it is usually zero. I would like to know the matter that evoid to plot the curve.

Your Phase Noise set-up is not correct.You should define PN in HB Noise Controller only and Nonlinear Noise is not your case.

I disable this case of"Non linear noise", but the curve still equal as zero. What can i do please?

I'm very gratefull if you send me the tutorial which is related to my goal i need just to plot the phase noise of this LC VCO.

so, how can i adjust the "Noise analysis in HB controler" and "HB Noise Controller" to have the spectrum of the phase noise.

You set two noise analyses
(1) Noise analysis in HB controler
(2) Noise Controler

You can find another phase noise data in data set.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:ADS model Doide s-param
下一篇:Noise figure and Isolation in ADS

ADS培训课程推荐详情>>

  网站地图