• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > voltage controlled model selection in Keysight ADS

voltage controlled model selection in Keysight ADS

录入:edatop.com    点击:
Hi

I have to use two distinct models depending upon the node voltage, something as follows:



The diodes D1 and D2 have different properties/models. If the voltage at node v1>0, then I want node v1 to be connected (perfectly shorted) to the D1 (as if D2 is not there at all), otherwise to D2 (as if D1 is not there at all).

I wonder if this kind of voltage dependednt use of model would be possible in Keysight the ADS? In fact, I have tried it using SDD as shown in the following:



But, I am not sure if SDD results into a perefctly shorted connection. I guess, it "shields" the parasitics of diodes from rest of the circuit.

(1) If my way of using SDD in this scenerio corect?

(2) If not, what else could be a better solution?

Thanks in advance.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:In ADS, is there a way to tune values of components using only standard values only?
下一篇:[ADS] designing series coils (spiral inductors)

ADS培训课程推荐详情>>

  网站地图