- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
Add new BandPass and Amplifier in ADS
I want to know how to add a new band-pass filter and amplifier to ads.
for Example, I selected this band-pass filter:
https://www.minicircuits.com/WebStor...l=BFCN-8450%2B
How can I create a new component(above component) to ADS?
In addition, for Amplifier with this specification how can I add it to ADS?
https://www.minicircuits.com/WebStor...odel=LHY-84%2B
Any videos or tutorial?
S-parameters are given, what else you want ?
Than you Bigboss for you comment,
Yes, I have added a S2P component and added a s-parameter file for my amplifier. It works fine that I can see s-parameters diagrams. But How can I add NF( noise figure) to this component too?
You can add noise figure to the S-Parameter file, see https://ibis.org/connector/touchstone_spec11.pdf
If Noise Figure parameters are added into s-parameter file, it's OK.You can directly simulate it.But if they are not included into, you have nothing to do because NF parameters are measured ones and you have to either to measure or request from manufacturer.
Note that : Insertion Loss of a passive device ( filter,diplexer etc. ) is simultaneously Noise Figure, so you can write them directly into s-parameter file by Touchstone format definition.For amplifier, you cannot know this..
The S2P files linked above don't have noise figure included.
I would expect that ADS uses noise figure =insertion loss, unless there is something else defined in the file? But wait ... that's valid for passive devives only. So what does ADS do then?
Thanks Volker and BigBoss for your comment,
I need to do harmonic balance to for my mixer. But I was not successful to find the S-parameter and spur table for my dipole S-parameter device. (mixer:SIM-153+) could you help me?
S-parameters are not used for HB..The Mixer which you intend to use is a Diode+Transformer Type Mixer, you will take it and use it.. That's it.
There is no information to analyze..
I really appreciate your help.
How can I define my mixer specification based on a Diode+transformer?
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:LVDS Modelling using ADS
下一篇:Help need to resolve Wire Connecting Problem in Agilent ADS2011.10
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集