• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > How do you model AM-AM and AM-PM of a PA on ADS?

How do you model AM-AM and AM-PM of a PA on ADS?

录入:edatop.com    点击:
Hi,

I have designed a Power Amplifier and have obtained AM-AM and AM-PM plots. I would like to include the S21 parameter file (which has both am-am and am-pm) and run some simulations on the link level where I can give WCDMA signal patterns etc. Do you know how to do that? I am new to ADS so I am finding it difficult to find the solution. Any help would be greatly appreciated and would save a lot of my time.

Thanks!

Use model based on X-parameters.
https://en.wikipedia.org/wiki/X-parameters
http://edadocs.software.keysight.com...ageId=93978692

Is it also possible to have a look up table on ADS?
I would like to have an one to one mapping between the output and input. I have the look up table. How would you implement that on ADS?

Usec DAC(Data Access Component) component.
http://edadocs.software.keysight.com...ageId=82848197

Read Chapter-5 of the following book.
http://www.amazon.com/Simulation-Com...ln_b_2&s=books

The following is might be useful for your purpose, although I don't like to use.
http://edadocs.software.keysight.com...ifier)-1137212

There are two nonlinear model based on file in ADS, , although I don't like to use.
http://edadocs.software.keysight.com...iles-P2DFormat
http://edadocs.software.keysight.com...ageId=82850775
http://edadocs.software.keysight.com...ageId=82850779

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:ADS Co-simulation Rectifier Circuit for RF Energy Harvesting
下一篇:Ads moment:how to simulate with different size of layers?

ADS培训课程推荐详情>>

  网站地图