- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
ADS Co-simulation Rectifier Circuit for RF Energy Harvesting
录入:edatop.com 点击:
Hello everybody,
I'm making an RF energy harvesting circuit using ADS schematic and Momentum Cosimulation.
First, I simulate the circuit using schematic then convert it into momentum to obtain the layout.
After that, I bring the layout to ADS schematic to attach the lumped components, Diodes and any other elements I'm using.
The question is when I compare both schematic results and co-stimulation results, it totally shows unmatched results, means I loss any matching in the circuit. I would like to make a tuning or optimization for the layout. I made the layout based on parameters then make tuning in schematic but it always shows an error message about the parameters changing.
Once sliding the parameter, the simulation immediately exit .
Anybody have advice, what I can do?
I checked connectivity and the circuit is appropriately connected
I'm making an RF energy harvesting circuit using ADS schematic and Momentum Cosimulation.
First, I simulate the circuit using schematic then convert it into momentum to obtain the layout.
After that, I bring the layout to ADS schematic to attach the lumped components, Diodes and any other elements I'm using.
The question is when I compare both schematic results and co-stimulation results, it totally shows unmatched results, means I loss any matching in the circuit. I would like to make a tuning or optimization for the layout. I made the layout based on parameters then make tuning in schematic but it always shows an error message about the parameters changing.
Once sliding the parameter, the simulation immediately exit .
Anybody have advice, what I can do?
Schematic simulation and Momentum layout simulation result may be a slight mismatch but it should not be totally off. Check physical layout connection from the input port to output port using connectivity tool. Also, check substrate stack up. which version of ADS are you using?
I'm using ADS 2014,
Results are totally different in values, Attached is the layout and substrate stack
I checked connectivity and the circuit is appropriately connected
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:exporting ads datafile to excel
下一篇:How do you model AM-AM and AM-PM of a PA on ADS?
ADS培训课程推荐详情>>
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集