• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > ADS load impedance matching for oscillator?

ADS load impedance matching for oscillator?

录入:edatop.com    点击:
Does anyone know how to set up a simulation in order to determine the load impedance that results in maximum power delivery for an oscillator? I have been trying to use LoadPull, but I am not sure if this is the right approach.

Alternatively, is there a way to simulate the S-parameters of an oscillator?

Thanks!

Load Pull can be used, no doubt.
If you consider the oscillator as an Power Amplifier, the principal is almost same,so max. power at the right impedance.
But..
Load Impedance is also quite deterministic on other specifications of the oscillator such as Phase Noise,Drift and Pulling effect.If you would obtain max. power from the oscillator, you may also loose some good stuffs ( maybe not ).

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:How to perform ADS Callback
下一篇:Rectifier and boost converter simulation in ads(RF energy harvesting)

ADS培训课程推荐详情>>

  网站地图