首页 > ADS > ADS FAQ > simulation using ADS sofrware

simulation using ADS sofrware

录入：edatop.com 点击：

Hi

In ADS software

In EM setup windows, in mesh tab, which is the accetable value of mesh frequncy and cells/wavelength?

and what is the effect of change these values on the simulation results?

Thanks

Hi,

I normally set my mesh frequency to the highest simulation frequency.
Cells/wavelength depend on the accuracy that you want. Increase it and see the results. for lower frequencies and accuracy, set it to 20.
Don't forget to enable "edge mesh".

If your design is in millimeter-wave frequencies, set the cells/wavelength to something close to 50.

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。

上一篇：ADS 2103， after adding 8HP PDK， no models available?
下一篇：Create a component from a schematic in ADS

ADS培训课程推荐详情>>

国内最全面、最专业的Agilent ADS培训课程，可以帮助您从零开始，全面系统学习ADS设计应用【More..】

simulation using ADS sofrware

Agilent ADS 栏目

频道总排行