• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > HB- Simulation in ADS

HB- Simulation in ADS

录入:edatop.com    点击:
Hi!
I want to design a power amplifier and I know one of the simulations which should be run is HB simulation. I have started with the test circuit of the transistor. after finishing this step I tried to run HB- simulation. But for some reasons it couldn't be converged. I don't know exactly what is the source of these errors. sometimes it complains there is a problem with DC and some other times small internal timestep.

Does anyone have any comments?

Regards,
Zahra

HB Simulations are a bit tricky so you have to check the simulation setup, active devices models', circuit topology etc. Unless you haven't provided the whole project file with models, there will be just some intuitive help.

Hi!
Thank you for the reply. So could I send to you the ADS file of my simulation?

Regards,
Zahra

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Modelithics Design Kit for Agilent ADS 2011
下一篇:How can I use voltage or current in the equation in ADS?

ADS培训课程推荐详情>>

  网站地图