• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Extraction of RLGC file of T-line in ADS

Extraction of RLGC file of T-line in ADS

录入:edatop.com    点击:
Hi,
I have created stripline/microstrip transmission line in ADS using Controlled impedance line designer (CILD). Now I want to extract the RLGC equivalent parameter file of that created transmission line. I know in the CILD option there is given RLGC parameter for single point. As RLGC parameetrs are frequency dependent I need to extract the RLGC per unit length for the created line at different frequency step along my frequency range just like s-parameter file, so that i can use this for other lines in ADS or even in Virtuoso also. It would be nice if someone help me about this on how to do it. Is it possible to extract RLGC for different frequency point from schematic or from the CILD tool?

I have attached an example of RLGC file (you can unzip & open that with any text editor). I want to extract file like that. Any idea how to do that in ADS?

Hi aguntukbd,

You can do this is you have equivalent network parameters, e.g., scattering [S] or transmission [ABCD] parameters. Which of these are easy for you to get?

Thanks, PlanarMetamaterials for your reply. scattering [S] parameter is easy for me to extract.

Perform an [S] to [ABCD] conversion. If you have MATLAB, you can use the "s2rlgc" command. Otherwise, you can find the conversion formulae anywhere online.

Then, look up how to extract the propagation constant γ and characteristic impedance Zo:

A = cosh(γl), where l is the length of the TL; therefore, γ = acosh(A)/l.

B = sinh(γl)*Zo, C = (1/Zo)*sinh(γl); therefore, Zo = sqrt(B/C).

Then you can solve for Z = R + jωL and Y = G + jωC as:

Z = γ*Zo
Y = (1/Zo)*γ

Good Luck!

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Port power for comparing radiation pattern ADS and HFSS
下一篇:Using ADS , how to find the Band Width of Amplifier Using Predefined BW function

ADS培训课程推荐详情>>

  网站地图