• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Need help to understand simulation results of rectifier circuit in Agilent ADS 2009

Need help to understand simulation results of rectifier circuit in Agilent ADS 2009

录入:edatop.com    点击:
I have simulated half wave rectifier ckt using ADS2009. i have following isssues regarding this.

1. i have made the proper matching ckt using smith chart utility for rectifier ckt i.e.my s11 is good enough but still why all power is not going into the ckt.
i know this depends on power level also ,but what is the criterion to do this.

2.whether i should to LSSP to understand this better i.e. SP is not the right thing to do here.

3. i have been looking into agilent application notes , but they never seem to discuss the efficiency of power transfer in such detector ckt.

4. generally what kind of eff.(%) (from input power to load power ) i am supposed to get from such half wave rectifier circuits.

I will really thankful for any kind of help in this regard. i am attaching the schematic , i can provide more detail if needed
regards
haresh

I think you have a few issues.
1) The TL1 is acting as a matched load at the input of your circuit, and TL 2 and the Didoes ect is in parallel so
that will cause a mismatch.
2) Your third terminal of your Diode is not connected to anything, so it's a high impermanence open, and does not
matter if it's on or off.

And are you looking for the rectified DC output ? If so your efficiency will be dependent on the input RF Power level.
If it is not strong enough to bias the Diode you will not get DC out . You should look in to AC and DC simulations.

Cheers.

TL1 and TL2 combined together are providing the matching to diode,cap. and load R altogether. i.e. S11 parameter was obtained obtained at fix input power -20 dBm.My confusion is why S11 at 915 MHz(my operating freq) is -34db.and at the same time when i do HB simulation my power probes are not showing at least good power transfer. because TL1 and TL2 are ideal no loss in them, so power probe 1 and probe 3 should show good power transfer?are s11 date is misleading

You can see s11 i an sending the file.

regards

- - - Updated - - -

here is the project file

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Help need in Class A Microwave transistor Power amplifier design in ADS at 18-26 GHz
下一篇:How define Q-factor of filter in Agilent ADS

ADS培训课程推荐详情>>

  网站地图