I need help in ADS 2009 simulation

Hi guys,

I made filter simulation in ADS 2009 schematic. It goes OK, and the results are correct. Then I wanted to make layout simulation, I used "Generate/Upadate layout" option but the results are completely wrong. Can anybody help me?

In attachment I gave you this project.

Hello,

I think you need to add the capacitors and inductors?

In the layout you are correctly simulating the layout but remember there is no components.

To do this you have to place an internal port where you have a component terminal. Then you can make a layout component to be used in schematic. There it is possible to place capacitors and inductors.

You also need to add the vias in layout...

Regards

Thank you very much for advice. I'm newbie with ADS. I'll try to do this, thanks again.

Here tyassin is talking about cosim feature with ADS provides.... place the internal ports and then generate the layout component of the layout.. place it in different schematic and then place the L and C components to do a co-simulation.

Thank you guys for advices. Ill try to do this all.

Hi
check these links out!

Index of /~rmh072000/Site/Software_and_Links_files

http://www.eas.uccs.edu/wickert/ece5...S_session1.pdf
http://www.eas.uccs.edu/wickert/ece5...S_session2.pdf
http://www.eas.uccs.edu/wickert/ece5...S_session3.pdf
http://www.eas.uccs.edu/wickert/ece5...S_session4.pdf

regards

Also you can use non linear demokit kept at "<ADS Installation directory>/examples/design_Kit". If you want capacitors and inductors in layout also.

申明：网友回复良莠不齐，仅供参考。如需专业帮助，请学习易迪拓培训专家讲授的ADS视频培训课程。