- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
【Help】ADS PA design!
You need to first define your requirements i.e. Power gain, output/input Power , S11 , S22 etc..
follow the following document.. simulate and see if you come up with same results! then invoke your requirements !
here is agilent's PA designguide,hope it would help youPower Amplifier.pdf
You must have output load pull impedance. If you have transistor model, a simulation software (ADS, Ansoft Des,..) can help you. and if you have not refer to datasheet and find that datas.
good luck.
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:need Help in antenna design in ADS
下一篇:Problem in Harmonic Balance in ADS2009
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集