• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > 3 layer simulation in ADS

3 layer simulation in ADS

录入:edatop.com    点击:
hi ...i have to model a 3 layer PCB.....my layers should be in the following way....
free space
cond1(micro strip)
substrate
ground
substrate
cond2(microstrip)
free space
how to model this in ADS momentum and i also want coupling between cond1 and cond2 .....how to define the layers.....

If you put an ideal ground plane between the two substrates, there will be no coupling between them.
You have to put slots on the ground plane or vias between cond and cond2
Good luck

ideal ground plance ( between two layers ) is not posible to model in ADS.

It will exit either on top side or bottom side.

I suggest more study on ADS momentum manual on substrate definition,layers etc.

You can create a slot type layer between the two signal planes, then the slot type layer will be considered to be an infinite ground plane.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:layout of one end joined coupled line (in ADS)
下一篇:T-junction discontinuity in ADS

ADS培训课程推荐详情>>

  网站地图