• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > Panasonic ADS resistor models

Panasonic ADS resistor models

录入:edatop.com    点击:
Good Evening
In an LNA design i have used the Panasonic ADS kit because it has some resistors i want to use. But when i change the ads resistor with the resistors from the kit, the noise figure drops. Is that possible? Usually when using resistors from manufacturers the noise is being increased... Is there any possibility to be something wrong with the kit?

If a resistor have more reactive parasitics (as capacitance or inductance), there is a possibility the input match of the LNA to move closer to gamma optimum, and get lower NF.

When you do Simulate > Generate Netlist, and open the netlist on a text editor, you can check the device models for missing/additional parameters.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:different resultat in simulation with ads and HFSS
下一篇:Output power at 0Hz ADS HB simulation

ADS培训课程推荐详情>>

  网站地图