• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > TSMC RF CMOS 0.18um (How can I add an inductor and a capacitor symbol in ads)

TSMC RF CMOS 0.18um (How can I add an inductor and a capacitor symbol in ads)

录入:edatop.com    点击:
Hi everyone,

I have a .net file(CMOSP18 "rf018.net") of TSMC (0.18um Mixed-Signal SALICIDE(1P6M+, 1.8V/3.3V)),and I have been using the "Netlist Include" component in ads 2009, only for simulating MOSFET(just by changing model name of MOSFET),and I could run simulations without any trouble.

Now, I would like to add some passive components like inductors and capacitors on the circuit, but by using inductors and capacitors of the "rf018.net" model.

Does anyone know how I can do it?
I tried to use also a "Netlist Include", but which symbol in ADS that represents the inductor model and a capacitor model that could be used with the same variable parameters as they are reserved in "rf018.net" model ?

Once again,thanks a lot.

check if you have access to a RF library with Cadence

Thanks seddik,

but I do not have RF library,
I just have the model file and ADS 2009

Hi
Can u please provide me TSMC RF CMOS 0.18 or 0.13 design kit for ADS 2011?

yes.. email me to send you the design kit.

m.dabibi@mobinnet.net

enjoy.

plz send me the above mentioned design kits at:

engryasirsabir@gmail.com

Thnx

If you dont mind please send tsmc_rfcmos_018um for ADS2011 to my email: ntkhanh36@gmail.com
Thank you very much!

Hi lamda
Can u please provide me TSMC RF CMOS 0.18 or 0.13 design kit for ADS 2011?

Hi lamda
Can u please provide me TSMC RF CMOS 0.18 or 0.13 design kit for ADS 2011?
My Email guxintao2007@126.com

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:inserting s parameters to ADS
下一篇:How do I read Mixed-Mode of S4P file in ADS ?

ADS培训课程推荐详情>>

  网站地图