• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > ADS Layout Help needed

ADS Layout Help needed

录入:edatop.com    点击:
hi everybody!

i have designed a wilkinson Power divider in ADS,
in the schemetic it is working best but when i generate layout,
i have no idea how to place shunt resistors(lumped element in case of schematic) between the microstrip lines. ..

when i calculate W and L for equalenct value for resistance, and place them between the m-lines, it changes results!

How can i place shunt resistor (lumped element ) in my Layout to simulate correctly.?

thanx !

You can simulate EM mircostrip lines by ADS momentum. And put your ports or terms for shunt resistor. when EM simulation was finished, you can recall this simulation data in the ADS.

PS:
You can simulate EM mircostrip lines by ADS momentum. And put your ports or terms for shunt resistor. when EM simulation was finished, you can recall this simulation data in the ADS.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:problems in recevier simulation with ADS
下一篇:IM2 calculation with ADS

ADS培训课程推荐详情>>

  网站地图