• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > simulating a NETLIST in ADS from the command line?

simulating a NETLIST in ADS from the command line?

录入:edatop.com    点击:


Hello friends,
Thanks for read this.

- I want to do optimizations in a circuit from a MATLAB environment (for example).
- I want to use the harmonic balance analysis in the ADS simulator.

But...

- I don't know how generate a ADS NETLIST.
- I don't know how run ADS with that NETLIST from the command line.
- I don't know how export results from a dataset of ADS from the command line
and/or how to configure the export_results_to_file component.

(This kind of things are very easy to do with LTSPICE or QUCS).

Thanks in advance,
Eduardo

% hpeesofsim [-r output_rawfile_name] [netlist_inputfile_name]

See "Running a Simulation from the Command Line" of the following.
http://edocs.soco.agilent.com/displa...r+Input+Syntax

Also see http://edocs.soco.agilent.com/displa...rite+var%28%29

You can use "dsdump" command to dump ds data as ascii file.

hello pancho..
thanks for your help
I have been palying with a ADS and with this simple line in a MeasEQN block:

x=write_var("/home/edu/borrame.s2p","W","#Hz S RI R 50"," ","f",,freq,S11,S21,S12,S22)

and I can export to a S2P file after simulating a circuit.

If you want to export S-parameters, you had better use "write_snp()" not "write_var()".
http://edocs.soco.agilent.com/displa...rite+snp%28%29

still new to ADS here, i looked at the links but am confused where to add the write_var command. can you put it directly in the netlist file? and where is the MeasEQN block found?
-thanks!

If you would like to do so, insert following line in netlist.
Using Measurement Expressions in Advanced Design System - ADS 2009 - Agilent EEsof Documentation Center

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:how to get equations from ADS template?
下一篇:What cause this error message of ADS Momentum simulation?

ADS培训课程推荐详情>>

  网站地图