- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
Help with circuit in ADS
My problem is: I add two signals at GATE of BF998, but I do not see the diferencies about this signals on the output MOSFET I could not see the differences in the entry signals. Maybe I need to put some parameter that I am omitting. The design is I it working but I need simulate these results, I hope you can help me.
That means your mixer does not work. Did you check the design?
Why do the 2 input signals power show similar power level? As I know, usually there is a low power frequency input.
-You can not connect the signal source without DC blocking capacitors otherwise bias will be short circuited with source impedance e.g. 50 Ohm.. Your bias flies away..
-You can not connect your sources by simply parallel connection because they will influence each other..
-The source impedances are define in properties dialog of source, you shouldn't connect a extra resistor in parallel.
-For N-MOS transistors, VGS must be positive ( E-Mode ) so your VGS bias circuit is not correct.But If you have used D-Mode devices, it's OK, it may work..
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:how to plot radiation pattern for antenna in schematic window of ADS
下一篇:How can I do a VCO "post simulation" in ads(not mo
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集