- 易迪拓培训,专注于微波、射频、天线设计工程师的培养
problem when i made simulation momentum in ADS
I have a project of design Amplifier at 4 GHz in ADS and when i made DC_BLOCK I had a good result for S11&S12 but when i simulate it by Momentum i had a bad result, so i don't know where is the problem.
you can see my numbers.
thx
Judging by the picture of the schematic, it doesn't seem like you've used the MSTEP block under TLines-Microstrip.
Your conductor goes from width, 'w' to width, 'wc' and this difference in width creates some more parasitic capacitance that isn't realized in the regular ADS simulation. You need to include thes MSTEP at every junction that there is a change in conductor widths and adjust your lengths accordingly to get your desired response.
As a first level of troubleshooting, I think this will match up your ADS simulation with your momentum simulation. Hope that works.
thank you for your advice but that doesn't solve the probleme.
In fact, i have good result befor making momentum and you can notice that my first figure at 4GHz is perfect and in the momentum it will be good at 3GHz.
I went ahead and setup your schematic as shown in the first jpg and simulated it in ADS and momentum by just importing it directly to the layout and setting up momentum and then running momentum. My ADS simulation matches yours. However, my momentum simulation is in line with my ads simulation, not what your momentum simulation looks like.
So it must be how you setup your momentum simulation. What are the steps you take to set up your momentum? It might be easier for you to post your project folder and I may be able to go through it...
I posted my project in this link:
https://www.edaboard.com/ftopic368109.html
Please just take the final file(.PDF), so also i share you your opinion about my parameter of momentum but i put it by defult and i take Momentum (without RF Mode) - simulation - s-parameters-simulate
Sweep mode:adaptive
sample point limit: 15
At any cases, please can you attach the picture of your simulation of momentum.
thx for your time.
I'm confussed on what you did in Momentum. Did you define your substrate, set it up, and then define and set up the mesh before you simulated your s-parameters?
thank you, i resetup my values on mesh and i got good results.
my project doesn't finish, so see you on next level:D
Bye
good to see you got it ... good luck
申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程。
上一篇:Could someone explain the Layout layers of ADS?
下一篇:ads anmx
国内最全面、最专业的Agilent ADS培训课程,可以帮助您从零开始,全面系统学习ADS设计应用【More..】
- Agilent ADS教学培训课程套装
- 两周学会ADS2011、ADS2013视频教程
- ADS2012、ADS2013射频电路设计详解
- ADS高低阻抗线微带滤波器设计培训教程
- ADS混频器仿真分析实例视频培训课程
- ADS Momentum电磁仿真设计视频课程
- ADS射频电路与通信系统设计高级培训
- ADS Layout和电磁仿真设计培训视频
- ADS Workspace and Simulators Training Course
- ADS Circuit Simulation Training Course
- ADS Layout and EM Simulation Training Course
- Agilent ADS 内部原版培训教材合集