• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > ADS Via Configuration

ADS Via Configuration

录入:edatop.com    点击:
Hello guys. I need some help with the via configuration dialog box in ADS.

First of all, check my layer stackup out:-

FreeSpace (open boundary)
RO4350b
PrePreg
FR4
Air (open boundary)

And here is some detail of the metallization:-

FreeSpace
-------- -STRIP-RouteLayer1
RO4350b |VIA| diel2
-------- -SLOT-cond2
PrePreg |VIA| diel
-------- -SLOT-cond3
FR4 |VIA| diel3
-------- -STRIP-RouteLayer2
Air

Please see if I'm going at it the right way. The board is a 4 layer board with RouteLayer1 and RouteLayer2 as RF and control signal routing layers respectively. Whereas, cond2 and cond3 are GND and Power planes.

Now, I want to be able to connect vias from RouteLayer1 and RouteLayer2 to all metallization layers. I'm getting stuck at the Via Configuration dialog box (Options>Via Configuration...).
I cant seem to be able to add any via to the list. Please help me out here.

Also, as a corollary, I need a solution to connect a STRIP and a SLOT layer.

Thanks and regards.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Help needed on advanced sysytem design (ADS)
下一篇:Schematic to layout in ADS

ADS培训课程推荐详情>>

  网站地图