• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > help regarding current source in ADS

help regarding current source in ADS

录入:edatop.com    点击:
hi all...

i want a voltage controlled current source of the form gm*V*exp(-jwt)..how can i put it in my schematic using SDDP or any other thing...

am new to ADS..so dont know much about it..

hi deeptimongia,
In the component palette, left hand side drop down list, select Sources-Controlled.
VCCS is waht you are looking for.

good luck,

no actually...VCCS is a linear source...
i want one that will generate the characteristics of the form gm*V*exp(-jwt)....In simple terms i want to define a current source to meet my specifications. This is possible with the help of SDDP but am not able to define its parameters..the exp(-jwt) term is a problem...

But in this model you can define T,G, and f

If you want to define your own equation you can use
Eqn Based-Nonlinear/VCCS

good luck,

even that equation based nonlinear is not helping me out...it gives a polynomial dependence of current on voltage...and mine is not that..

hi again,
Try Eqn Based-Nonlinear/SDD.
Hope it helps this time,

thanks !..
have already tried and worked out..

Hi all
I need to simulate a small signal equivalent FET in ADS... a S parameter simulation...i don't know how to place the voltage controlled current source...i tried with equation based liniar...but i don't know how to connect it in my circuit..i am new in ADS...i need urgent help plss

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:Defected Ground Structure using ADS 2009
下一篇:About lna and mixer design using ads

ADS培训课程推荐详情>>

  网站地图