• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > ADS optimization based on equation

ADS optimization based on equation

录入:edatop.com    点击:
is it possible to optimize something in ads upon an equation?
I need an sloped characteristic for S21 in a defined frequency range, how can I optimize circuit parameters to yield the goal?

Describe your needs in detail.

pancho_hideboo
as described I want to have a roll up (to compensate the roll off in a broad band width), for this I am going to optimize a broadband hybrid ( constructed from edge coupled strip lines) but have no idea about the optimization method.
dose ADS accept an equation in its optimization as goal for example |S21- a sloped line|<.1dB?
how can I do that?

What do you mean ?

Again describe correctly.

Basically you can use "Measurement Expressions" as Goal for Optimizer.
You can use expressions including "freq" which is simulator's reserved variable.
See documents of ADS. Also you can use conditional statements such as "if then else endif".

You can use math function with expression:
use max() for S21 dB maximum;
use min() for S21 dB minimum;
delta1=max()-min()
then use delta1 as goal to say 0.5dB

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:simulation of PIFA antenna in ADS
下一篇:How can I simulate the Q of balun by ADS?

ADS培训课程推荐详情>>

  网站地图