• 易迪拓培训,专注于微波、射频、天线设计工程师的培养
首页 > ADS > ADS FAQ > URGENT HELP FOR USING ADVANCED SYSTEM DESIGN SIMULATOR (ADS) IN MOBILE WIMAX(802.16e)

URGENT HELP FOR USING ADVANCED SYSTEM DESIGN SIMULATOR (ADS) IN MOBILE WIMAX(802.16e)

录入:edatop.com    点击:
Hello members, am using Agilent ADS software to carry out performance studies on Mobile WiMAX (802.16e). My studies are based centrally upon the performance of Mobile WiMAX and on its use of Multiple Antenna Adaptive Systems [MIMO(Multiple-Input-Multiple-Output)] channels to improve network coverage, increase throughput and decrease the bit or packet error rates .
I am to carry out performance simulations on this, checking the fading levels, sensitivity, constellation points etc.

I have started simulating on the templates on the "mobile_wimax_mimo_Rx_prj". I made some changes such as "antenna correlation type", "Rate ID", "Decoder type" etc.... , but after the simulation was completed, it displayed the trace and plot options only. I keyed-in the necessary values and details, but at the end of it all, it didn't display any graphical results, but only displayed an empty graph showing x-axis and y-axis.

Anyone with a clue on this should please help me out, because i don't have much time anymore.

Thanks,
Emyboard.

申明:网友回复良莠不齐,仅供参考。如需专业帮助,请学习易迪拓培训专家讲授的ADS视频培训课程

上一篇:how to set the "LimiterSML" in ADS
下一篇:Is it possible to enter RLGC data of a transmission line in ADS ?

ADS培训课程推荐详情>>

  网站地图